Message Menu

The Message menu displays the code conditions. Messages are recorded in the controller memory to simplify unit diagnostic procedures.

Display will show either NO MESSAGES or the newest MESSAGE. A Message indicates corrective action should be taken before a problem becomes severe. When a Message occurs, the controller will try to determine if the component or input is good or bad. The Message description will be displayed across the top of status display and the Red LED will not be illuminated. If the controls determine the component or input is bad, the Message will become an Alarm.

1. Press the Enter key to view the Main menu.

2. Press the Up or Down key to scroll to the Message menu. Press the Enter key to access.

   Open

   Display will show either NO MESSAGES or the newest MESSAGE.

   Open

   Open

   Note Messages are displayed in sequential order, not in order of occurrence.
   The first alarm code number, alarm state, and alarm description appears in the display id there are messages.

3. Press Up or Down key to view next message when more than one message has been recorded.

   Open

4. To clear all messages from the current display list and turn off the Alarm LED, all problems must be corrected.

5. Press Enter key to acknowledge the message. The message state will change from Active or Not Active to Acknowledge. If no key is pressed for 30 seconds, the controller returns to previous menu level or Unit status display.

For a complete list of status messages and controller actions, see (Status Messages and Controller Actions).