Changing Setpoint

To change the controller setpoint, turn the Unit ON. Allow Unit to start and stabilize. Complete the following steps:

  1. Press the F3 key at the main screen. The Setpoint Change menu appears.

  2. Press the F2/F3 keys to scroll the Setpoint Up or down - depending on your required temperature.

  3. Press and hold the F4 key until you are returned to the main screen. The new setpoint is recorded in the controller and appears in the display.

    Note The controller will default (return) to the previous setpoint if the setpoint is not entered within 30 seconds. Repeat steps 1 through 3 if this occurs.

Note Defrost Terminate Temp, Defrost Internal, and USDA Trip can be set from the Setpoint menu. Refer to “Setpoint Menu” under “Menu Operating Instructions” in this chapter.
Parent topic: Standard Display