Changing the Setpoint - Named Product
If the TemperatureWatch display is shown, press any soft key to return to the Standard Display. From the Standard Display, press the PRODUCT Key. Note that PRODUCT is displayed in place of SETPOINT ( Product Displayed).
The display briefly shows PRODUCT and then the setpoint display appears ( Setpoint Display).
The -
and +
Keys are used to change the Named Product
until the desired product is shown. The product has been changed to
Potato, Late Crop ( Named Product).
The YES and NO Keys confirm the product change ( Yes and No Keys). When the desired product has been selected using the +
and/or -
Keys, press the YES Key to confirm and load
the new product. If the product is changed using the +
or -
Keys, the change must be confirmed or rejected by pressing
the YES or NO Key within 10 seconds of changing the product. A warning
beep will sound for five seconds as a reminder.
Failure to confirm the new product by pressing Yes or No within 10 seconds of changing the product will result in no product change. In addition, Alarm Code 127 Setpoint Not Entered is set, to indicate that the product change was initiated but not completed.
After the YES Key has been pressed, the display briefly shows PROGRAMMING NAMED PRODUCT - PLEASE WAIT. The display then confirms the new setpoint for several seconds ( New Named Product).
If the NO Key is pressed the display will briefly show SETPOINT NOT CHANGED and return to the Standard Display. The Standard Display will show the old setpoint.
The display then returns to the Standard Display showing the new named product. Notice that the arrow points down, to indicate that the unit is cooling ( Standard Display).
+or
-Keys, the change must be confirmed or rejected by pressing the YES or NO Key within 10 seconds of changing the named product.
-
If the YES Key is pressed, the product change made with the
+
or-
Key is accepted, the product changes, and the display returns to the Standard Display. -
If the NO Key is pressed the product change made with the
+
or-
Key is not accepted, the product is not changed, and the display returns to the Standard Display. -
If the YES or NO Key is not pressed within 10 seconds of making a change with the
+
or-
Key, the product is not changed and the display returns to the Standard Display. The display briefly shows [SETPOINT NOT CHANGED] and Alarm Code 127 Setpoint Not Entered is set, to indicate that the product change was initiated but not completed.
See Changing the Setpoint - Named Product () for an overview of the procedure.