If a Flash Drive is Connected

If a properly configured USB Flash Drive is inserted in the Flash Drive Only USB Port on the Control Panel when the unit is turned on, the display ( Flash Drive) will briefly show FLASH DRIVE.

Flash Drive

The FLASH DRIVE DETECTED and the Flash Drive Menu will appear on the display ( Flash Drive Menu). The display will be shown for about 30 seconds and then the Standard Display will appear. To go to the Standard Display, immediately press the EXIT Soft Key.

Flash Drive Menu

Important The engine start is not delayed by the Flash Drive Menu shown above. The engine start prompt will appear and the engine will start. After the engine is started the display will return to the Flash Drive Menu or the Standard Display.

If a properly configured USB Flash Drive is connected to the USB Flash Drive connector, this feature allows the operator to select the desired Flash Drive function. If enabled when the Flash Drive was configured, the following functions may be available:

  • DOWNLOAD

    • Download the ServiceWatch Data Logger

    • Download the CargoWatch Data Logger

  • FLASHLOAD

    • Flash load Base Controller Software

    • Flash load HMI Control Panel Software

  • OPTISET PLUS

    • SEND

      • Send OptiSet Plus files

    • RETRIEVE

      • Retrieve OptiSet Plus files

The Flash Drive is also available from the Main Menu.

The Flash Drive Menu will time out about 30 seconds after the engine starts. When the Flash Drive Menu times out, the Standard Display will appear. To go to the Standard Display, immediately press the EXIT Key.

Parent topic: Turning Unit On