System Setup

The System Setup submenu contains the following:

• Current RPM, which is used to check the engine speed.

• Speed Solenoid, which is used to request a speed change to the ECU.

• Tank Size (50/75/80/125), which is used to set the unit fuel tank size.

• Fuel Sensor (Yes/No), which is used to setup units with a fuel sensor. Unit with fuel sensor Yes, unit without fuel sensor No.

• Date, which is used to set the date. See “Misc. Functions Menu” on page 78 for information about setting the date.

• Time, which is used to set the time. See “Misc. Functions Menu” on page 78 for information about setting the time.

• ID Number, which is used to set an ID number to identify the unit when downloading the event logger.

• Serial Number, which is used to set the unit serial number in the controller menu.

To enter the System Setup submenu complete the following steps:

1. Place the On/Off switch in the “ON” position.

2. Press the ENTER key or the ESCAPE key to enter the Main Menu, if necessary.

3. Press the UP or DOWN key to scroll up or down through the Main Menu to the Commands Menu.

4. Press the ENTER key to enter the Commands Menu.

5. The PTI submenu will be displayed.

6. Press the UP or DOWN key to scroll up or down through the Commands Menu to the System Setup submenu.

7. Press the ENTER key to enter the System Setup submenu.

8. Press the UP or DOWN key to scroll up or down through the System Setup submenu.

9. Press the ENTER key to enter the selected function.

   • Press the UP or DOWN key to change the value of the selected function.

     Note The engine speed will change when the UP or DOWN key is pressed.

   • Press the ESCAPE key and the ENTER key at the same time to save the new Tank Size setting.

     Note Press the ESCAPE key to return to the System Setup submenu without saving the new settings.

   • Press the ESCAPE key to return to the System Setup submenu.