Inspection and Service Intervals
Inspection and Service intervals are determined by the number of unit operating hours and by the age of the unit. Examples are shown in the table below. Your Dealer will prepare a schedule to suit your specific needs.
Service Record: Each inspection and service performed should be recorded on your Dealer Service Record.
| Interim Inspection | Complete PM | Full Service |
|---|---|---|
|
A Service Every 1500 hours or every 12 months (whichever comes first) Every 1000 hours or every 6 months (whichever comes first) |
B Service Every 3000 hours or every 24 months (whichever comes first) Every 2000 hours or every 24 months (whichever comes first) |
C Service Every 6000 hours or every 48 months (whichever comes first) Every 4000 hours or every 48 months (whichever comes first) |
| Interim Inspection | Complete PM |
|---|---|
|
A Service Every 1000 hours or every 6 months (whichever comes first) |
B Service Every 2000 hours or every 24 months (whichever comes first) |
| Interim Inspection | Complete PM |
|---|---|
|
A Service Every 1000 hours or every 12 months (whichever comes first) |
B Service Every 2000 hours or every 24 months (whichever comes first) |
| Pretrip | Inspect/Service These Items | |
|---|---|---|
| • | Run Pretrip Test (Refer to Operating the SR-3 Controller). | |
| • | Check fuel supply. | |
| • | Check and adjust coolant/engine oil levels. | |
| • | Listen for unusual noises, vibrations, etc. | |
| • | Visually inspect unit for fluid leaks. (fuel, coolant, oil and refrigerant). | |
| • | Visually inspect unit for damaged, loose or broken parts (includes air ducts and bulkheads if so equipped). | |
| • | Visually inspect belt. | |
|
Note For further
best practices, please go to www.europe.thermoking.com/best-practices.
|
||
| Pretrip | Inspect/Service These Items | |
|---|---|---|
| • | Run Pretrip Test (Refer to TSR-3 Controller). | |
| • | Check fuel supply. | |
| • | Check and adjust coolant/engine oil levels. | |
| • | Listen for unusual noises, vibrations, etc. | |
| • | Visually inspect unit for fluid leaks. (fuel, coolant, oil and refrigerant). | |
| • | Visually inspect unit for damaged, loose or broken parts (includes air ducts and bulkheads if so equipped). | |
|
Note For further
best practices, please go to www.europe.thermoking.com/best-practices.
|
||