Printing a Trip Report

The optional Thermo King TouchLog datalogger printer allows you to print a record of such things as the unit microprocessor controller identification numbers, dates and times, the setpoint, and the data from the optional Compliance Log sensors . If no sensors are connected, the printed record shows the same information without the sensor data.

  2. Locate the printer connector - located inside the unit door (close to the A-Series Controller) as shown below.

  3. Remove the connector cover.

  4. Connect the Printer Connector (From Printer harness) to this Printer Connector.

  5. Connect the spliced wires on the other end of the Printer Harness into the connection location at the back of the Printer.

  6. Please refer to your TK 61009-11-OP TouchPrint Operator Manual at EMEA Operator Manual Website(or third party printer manual) for instructions for setup and use.

Note For additional information concerning the TouchPrint Printer or TouchLog Datalogger contact your Thermo King dealer.

Parent topic: Operating Instructions