Note The Main On/Off Switch must be in the “ON” position for the unit
to operate.
Note The Service Switch must be in
the “ON” position for the unit to operate.
Turn unit on by pressing
the ON Key.
Note System startup sequence may take up to
60 seconds.
Diesel engine preheats and starts are automatic
in both Continuous Mode and Cycle Sentry Mode. The engine preheat
and start will be delayed in Cycle Sentry mode if there is no current
need for the engine to run.
Note If Electric Standby is
active, there may be some additional prompts before the engine/electric
motor will start.
System Startup Sequence Shown
Once the system startup sequence is completed, the Standard
Display will appear and unit will start in the Diesel Mode (if no
Electric Standby is detected).
Note Operating Mode: The
unit retains the last user configured operating mode when power cycled.
i.e. If the unit was running in Continuous Mode, and then power is
cycled, the unit would still remain in continuous mode.
The
temperature setpoint or other system changes can now be made if required.
Standard Display Showing - Unit Running in Diesel and Continuous
Mode
Turn the unit on by pressing
the ON Key. Diesel engine preheats and starts are automatic in both
Continuous Mode and Cycle Sentry Mode. The engine preheat and start
will be delayed in Cycle Sentry mode if there is no current need for
the engine to run.
Note
System startup sequence may take up to 60 seconds.
If Electric Standby is active, there may be some additional
prompts before the engine/electric motor will start.
System Startup Sequence
Once the system startup sequence is completed, the Standard
Display will appear and the unit will start in Diesel Mode (if no
Electric Standby is detected). The temperature setpoint or other system
changes can now be made if required.
Note Operating Mode:
The unit retains the last user configured operating mode when power
cycled. i.e., if the unit was running in Continuous Mode, and power
is cycled, the unit would still remain in continuous mode.
Turn unit on
by pressing the ON Key.
Note
System startup sequence may take up to 60 seconds.
If Electric Standby is active, there may be some additional
prompts before the electric motor will start.
Once the system startup sequence is completed, the Standard
Display will appear and the unit will start in Electric Standby Mode.
Note Operating Mode: The unit retains the last user configured
operating mode when power cycled. i.e., if the unit was running in
Continuous Mode, and power is cycled, the unit would still remain
in continuous mode.
The temperature setpoint or other system
changes can now be made if required.
Turn the
unit on by pressing the ON Key.
Note
System startup sequence may take up to 60 seconds.
If Electric Standby is active, there may be some additional
prompts before the electric motor will start.
System Startup Sequence
Once the system startup sequence is completed, the Standard
Display will appear and the unit will start in Electric Standby Mode.
The temperature setpoint or other system changes can now be made if
required.
Note Operating Mode: The unit retains the last
user configured operating mode when power cycled. i.e., if the unit
was running in Continuous Mode, and power is cycled, the unit would
still remain in continuous mode.
